Charger for Canon LP-E4 LPE4 EOS 1D 1DS Mark III

This LP-E4 charger for the rapid charger. A battery charging time is approximately three hours. It also has calibration, can accurately display the remaining battery power, also in charge of the electricity charge can display.

Charger specifications
● input voltage: DC 14.5V ~ 16V
● input current: 1000 mA
● output voltage: DC12.6V
● output current: 1000 mA
● temperature range: -20 ℃ ~ +40 ℃
● work humidity range: 85% (MAX)
● Dimensions (L * W *): 95 mm × 75mm × 41mm
● Weight (approx.): 100 g

To the battery charging method
● will DC power into the battery chargers, chargers four full-light, LED green (not with batteries).
● battery charger so that the correct installation of the deduction of clasped battery.
● charger fitted with batteries from the left when the first four red LED display that has entered the charging status. The first a green LED light that has sufficient battery voltage to 11 V. The first two green LED light that has sufficient battery voltage to 12 V. The third green LED-liang said that the charge current has less than 650 mA. No. 4 LED changes from red to green has said that the charge current of less than 50 mA, has been full of batteries. 4 lights corresponding to 30%, 50% and 80%, 100% of the electricity.
Warning
● charger dedicated to the interior of the charge, do not be exposed to rain or snow. ● Do not decomposed or assembly of the charger.
Attention
● Do not make the charger or will fall under its weight on.
● children must be under the supervision of adults use the charger.
● must 0 ℃ - 40 ℃ temperature range of use of the charger.
● Do not direct sunlight, heating equipment side or the other places use or storage of high temperature of the charger.